Table of Contents
Advertisement
Quick Links
CONTENTS
Warranty card attached
Thank you very much for purchasing this Panasonic product.
Please read these operating instructions carefully before operation and maintenance.
Also, be sure to read the "SAFETY PRECAUTIONS" section (P.2 ~ 5) before use.
Failure to comply with instructions could result in injury or property damage.
Make sure that the correct information is written on the warranty card, including the date of
purchase and the name of the distributor. Keep the warranty card in a safe place along with the
operating instructions for future reference.
Panasonic
"
OPERATING INSTRUCTIONS
Model No.
2 ~ 5
6
7 ~ 8
9 ~ 10
11 ~ 12
13 ~ 18
13
14
15
16
17 ~ 18
19 ~ 21
19 ~ 20
21
21
22 ~ 24
25
26 ~ 27
27
BACK COVER
2 ~ 5
"
Air Purifier
This product is for indoor use only.
·
2 ~ 5
6
7 ~ 8
9 ~ 10
11 ~ 12
13 ~ 18
13
14
15
16
17 ~ 18
19 ~ 21
19 ~ 20
21
21
22 ~ 24
25
26 ~ 27
27
Advertisement
Table of Contents
Related Manuals for Panasonic F-PXT175H
Summary of Contents for Panasonic F-PXT175H
-
Page 1: Table Of Contents
BACK COVER OPTIONAL ACCESSORIES Warranty card attached Thank you very much for purchasing this Panasonic product. Please read these operating instructions carefully before operation and maintenance. Also, be sure to read the “SAFETY PRECAUTIONS” section (P.2 ~ 5) before use. -
Page 2: Safety Precautions 2
SAFETY PRECAUTIONS Please strictly follow Disconnect power supply before maintenance. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. For cleaning see "maintenance“. This product is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the product by a person responsible for the... - Page 3 SAFETY PRECAUTIONS Please strictly follow WARNING In case of any abnormality or Do not insert your fingers, malfunction, stop using the metallic objects or others into product immediately and the air inlet, air outlet or gaps. disconnect the power plug. (Otherwise, you may be hurt by the (Otherwise, electric shock, fire or inner units with the possibility of...
- Page 4 SAFETY PRECAUTIONS Please strictly follow WARNING Insert the power plug Install a bipolar switch with the completely. contact separation not less than 3mm between the fixed wiring and the main body of this (Otherwise, the power cord may overheat with the possibility of fire or product electric shock.) 3 mm...
- Page 5 SAFETY PRECAUTIONS Please strictly follow CAUTION When disconnecting the Do not place the product in power plug, hold the power the following places plug instead of the power cord. Incline and unstable place. (Otherwise, the power cord may be (Otherwise, the product may fall over damaged with the possibility of fire or and injury may occur or damage the electric shock.)
-
Page 6: Setting And Operating Requirements
SETTING AND OPERATING REQUIREMENTS Area that can enhance the effectiveness! Place the product low on the floor as a countermeasure against PM2.5. PM2.5 Since PM2.5 and dusts are likely to float in the air near the floor, it is recommended to put the product on the flat floor in the room. PM2.5 Way to circulate air more effectively. -
Page 7: Product Features 7
SETTING AND OPERATING REQUIREMENTS With the efficient “composite and deodorizing filter” and “large air volume” design, it brings you fresh and clean air The efficient composite and deodorizing filter strongly filters out PM2.5 and formaldehyde PM2.5 Four sensors are equipped: a dirt sensor, an odor sensor, a light sensor and a human activity sensor The PM2.5 concentration reading display keeps you updated with the indoor PM2.5 pollution level... - Page 8 Test outcome: eliminated 99% and above in 8 hours [Test number 13044083003-01] (With one type in variety of bacteria to test) 13044083003-01 Test organization: Panasonic Corporation Analysis Center Test method: measure the allergens adhered on the fabric in a test space of 23 m with ELISA...
-
Page 9: Main Parts Identification 9
MAIN PARTS IDENTIFICATION Front Back Remote control Control panel (touch screen) Odor sensor Air inlet Front panel/Air outlet (nanoe emission outlet) ® Front panel Pre-filter lock cover (2 pcs) ® (nanoe Dirt sensor Power cord Wheels Power plug (4 on the bottom) (By moving the main When you want to fix the wheels: body back and forth,... - Page 10 MAIN PARTS IDENTIFICATION Light sensor PM2.5 concentration/timer display window Detects the indoor brightness by the light PM2.5 sensor, and automatically adjusts the Displays the PM2.5 concentration detected by brightness of the indicators and the air the dirt sensor, which may be different from volume.
-
Page 11: Setup 11
SETUP Before startup Install filters Fill in the label Installing composite and deodorizing filter. with the first date of use. Press the front panel lock cover (2 pcs) with both fingers at the same time. Front panel lock cover Front panel Notice When opening the front panel lock cover, the opening angle shall not be greater than... - Page 12 SETUP Install filters Power-on The arrow on the composite and deodorizing filter (2 pcs) Connect the power faces to the front panel and install it into the body. Rotate plug.(Please purchase a the filter hook 1 down and the filter hook 2 up, fix the power plug that follows filter.
-
Page 13: Operation 13
OPERATION This product adopts touch screen operation, contact area is as large as possible when using finger to press (if contact area is too small, may result in no response after touch). If power is disconnected while operating, when it is connected again, the product will automatically restart and operate in the mode it was in when power was lost. -
Page 14: Air Volume
OPERATION Air volume Select appropriate air volume for purifying air. Each press of the button, the air volume indicator switches in the order shown below. (button lights Auto (automatically adjust the air volume according to the air pollution detected by sensor, and use appropriate air volume to purify air ) Auto Silent... -
Page 15: Pm2.5
OPERATION PM2.5 Quickly remove PM2.5. PM2.5 Press this button to quickly remove PM2.5 and automatically control the air volume (air volume indicator is off), until the indoor PM2.5 concentration is lower than the PM2.5 concentration baseline (factory setting is 35 µ /m (button lights PM2.5 PM2.5... -
Page 16: Timer
OPERATION Timer Each press of the button will switch the time in the order below on the PM2.5 concentration/ timer display window. About 15 seconds after the selection is (button lights completed, the setting will be automatically saved, and the setting is completed. -
Page 17: Remote Control
OPERATION Remote control (touch screen) Remote control operation. Power off/on Operating methods button The tape must be removed before use Silent Auto (otherwise, the battery cannot be button powered on.) PM2.5 button PM2.5 When using, please point the signal transmitter The use of the buttons on the remote to the product and use it within the effective control is consistent with the use of... - Page 18 OPERATION Remote control (touch screen) Battery replacement method (Panasonic CR2025 is recommended. ) Panasonic CR2025 The service life of the battery is approximately 1 year. (Assumed that the button is pressed 20 times a day.) Pull out the battery holder...
-
Page 19: Maintenance 19
MAINTENANCE Notice WARNING Do not use the detergents Make sure to disconnect the Polish shown on the power plug before cleaning the right. product. (Otherwise, the product might operate with the possibility of electric shock or injury.) Do not operate the product when the When using chemically treated cloth, make composite and deodorizing filter is removed. - Page 20 MAINTENANCE Cleaning method Dirt sensor (about once every 3 months) Filter Hook 1 Wipe the dirt off the lens with a dry cotton swab Remove the cover of dirt sensor as shown below. Wipe the lens with a dry cotton swab as shown below. Filter side Lens(top left and top right) Dry cotton swab...
-
Page 21: Filter Replacement
MAINTENANCE Filter replacement composite and deodorizing filter Replacement period When the filter replacement indicator lights on Depends on the level of air pollution, time taken for the filter replacement indicator lights up is different. The filter replacement indicator is set according to the collection of particles by the filter, when the collection capacity of the particles reduces to a certain level, the indicator is on. -
Page 22: Further Information 22
FURTHER INFORMATION About nanoe nanoe ® ® nanoe can be switched off. nanoe ® ® During operation, press buttons at the same time for about 3 seconds nanoe indicator lights off) Press the buttons for about 3 seconds again to restart the nanoe ®... - Page 23 FURTHER INFORMATION About odor sensor dirt sensor · The sensor detects air pollutants and shows the pollution level by the clean sign. In auto operation, the product can optimize the air volume for purifying the air according to the detected pollutants.
- Page 24 FURTHER INFORMATION About brightness reaction Detects the indoor brightness by the light sensor, and automatically adjusts the brightness of the indicators and the air volume. When the room becomes dark during bed time, the indicator goes dim or lights off, and the product runs with low air volume.
-
Page 25: Faq
Please confirm the following before you put questions forward or send the product for repair. Why is a “jee” sound from Why does the clean sign light off the emission outlet? during operation? “ ” Since the light sensor detects that the There is a slight sound when nanoe ®... -
Page 26: Troubleshooting 26
TROUBLESHOOTING If a problem is encountered, please investigate it by going through the following items. If the problem still persists, please disconnect the power plug and contact the dealer for repair. Possible situation Please confirm the following The indicator may turn red when the product is subject to steam in the bathroom or vapor emitting from sprayers. -
Page 27: Specifications
TROUBLESHOOTING If any of the following cases occur, please contact the dealer immediately for repair. The PM2.5 concentration/ timer display window displays Product may be out of order. the letter F and two digits, like Please disconnect the power and contact the dealer for repair. PM2.5 SPECIFICATIONS Model number... -
Page 28: Optional Accessories
When PM2.5 Concentration / Timer display window shows the letter F with two numbers, such as , etc. The product may malfunction. PM2.5 Product may be out of order. Please disconnect the power and contact the dealer for repair. Panasonic Corporation Issue date: 12/2020 Web site: http://www.panasonic.com 12/2020 © Panasonic Corporation 2020...