Advertisement
3.
Fold the screen material over the frame to check the alignment.
In each corner, the edges of the screen material should align with the dashed lines shown in the illustration below, and the
circled screw holes should not be covered by the screen material.
4.
Hook one of the supplied springs through the hole in the corner of the screen material, and then use one of the included hooks
to attach the other end of the spring to the inside of the frame. Repeat this process for the other hole closest to the corner.
Warning: To avoid injury, attach the springs with the hooks and not your hands.
Caution: You can touch the screen material near the holes, but do not touch the screen material on the other side of the frame or you
may damage the screen.
Note: Hold the frame in place so that it does not move out of position while you are attaching each spring. If the frame moves, refer to
step 3 to reposition it correctly.
Note: Be careful not to bend or crease the screen material while attaching the springs.
5.
Repeat step 4 for the opposite corner, and then for the two remaining corners.
2 mm
2 mm
Assembling the Screen
9
Advertisement
