Advertisement
Mechanical design
The device consists of the following parts:
●
Touch panel with electronics, operating elements and built-in room temperature sensor
●
Mounting plate is an additional part to complete the installation for 5WG1205-2AB21
Operation and display
No.
①
②③
④
⑤
Note
●
Entering programming mode:
–
–
–
●
KNX programming function need to be done by professional engineers. Make sure this
function is disabled during daily operation and if it is enabled:
–
–
●
Micro SD card is used for modifying the background picture, electronic photo album,
icons for home page or multi-functional pages. SDHC card and FAT32 format are only
supported and the capacity of Micro SD cards is not greater than 32 GB.
4
Siemens
Smart Infrastructure
Product description
Display and touch operation area
Proximity sensor
Color light strip
Auxiliary power supply connection
terminal
Click the setting icon
Goes to "General";
Enable "KNX programming", then the colorful strip turns red and device can be
configured via ETS.
The device can operate normally.
The color strip is constant red and it affects the strip life span.
No.
Product description
⑥
Micro SD card slot
⑦
KNX bus connection terminal
⑧
Built-in temperature sensor
in home page;
Datasheet
A6V11980238_en--_a
2021-01-28
Advertisement
