Steam Burst Function; Safety Shut-Off - Silvercrest SDBE 2400 A1 Operating Instructions Manual

_CPE100696_Dampfbügeleisen_B2.book Seite 49 Freitag, 11. Juli 2014 10:34 10
1. Set the steam flow rate controller 3 to 0
and set the temperature controller 16 to
min.
2. Fill the water tank 15.
3. Connect the mains plug 9 with the wall
socket.
4. Set the temperature controller 16 to the
desired temperature (at least
temperature control lamp 11 lights up.
5. As soon as the ironing temperature has
been reached and the temperature con-
trol lamp 11 goes out, adjust the steam
flow rate controller 3 to the desired
steam flow rate
The steam will...
... start to come out as soon as you hold
the steam iron horizontal, and
... stop as soon as:
- you hold the steam iron vertically,
- the temperature is too low,
- the water tank is empty
or
- you set the steam flow rate control-
ler 3 to 0.
6. Finish ironing, set the temperature con-
troller 16 to min, set the steam flow
rate controller 3 to 0 and pull out the
mains plug 9.
7. Allow the steam iron to cool down, and
pour off any remaining water from the
water tank 15 through the filling open-
ing in the water tank (under the lid 2).

6.6 Steam burst function

The steam burst function requires a high tem-
perature. Select a temperature setting be-
tween and max. For this purpose, the
water tank 15 must be at least one quarter
full.
• Press the steam burst button 4
the steam iron glides over the item of
laundry.
• Wait a few seconds before you press
the steam burst button 4
NOTE: for smoothing items of clothing that
are hanging up, you can use the steam burst
in a vertical position.
). The

7. Safety shut-off

and start ironing.
Your steam iron possesses a safety shut-off of
the heating function (AUTO SHUT OFF).
Activating the function
The automatic shut-off occurs, if
- the device has stood still in vertical posi-
tion for approx. 8 minutes.
- the device has stood still on the sole
plate for approx. 30 seconds.
- the device has laid on its side for ap-
prox. 30 seconds.
When the safety shut-off is activated, an
alarm sounds for approx. 3 seconds and the
operating lamp 6 starts to flash until the
function is switched off.
Switching off the function
Pick up the steam iron by its handle 7 and
hold it horizontally for a few seconds or
make some ironing movements.
while
again.
DANGER! Fire hazard!
Despite the automatic shut-off, the
steam iron must not be left
unsupervised.
GB
49