Steam Jet Function; Cleaning - Silvercrest SDBK 2400 F5 Operating Instructions Manual

flow rate controller 3 to the desired
steam flow rate
The steam will ...
... start to come out as soon as you hold
the steam iron horizontal, and
... stop as soon as:
- you hold the steam iron vertically,
- you place the steam iron into the
stand 7,
- the temperature is too low,
- the water tank 15 is empty
or
- you set the steam flow rate control-
ler 3 to .
7. Finish ironing, set the temperature con-
troller 17 to MIN, set the steam flow
rate controller 3 to
mains plug 9.
8. Allow the steam iron to cool down, and
pour off any remaining water from the
water tank 15 through the filling open-
ing in the water tank (under the lid 2).

7.6 Steam jet function

The steam jet function requires a high tem-
perature. Select a temperature setting be-
tween and MAX. For this purpose, the
water tank 15 must be at least one quarter
full. The steam flow rate controller 3 is locat-
ed to the left on the symbol
• Press the steam jet button while the
steam iron glides over the item of laun-
dry 4 .
• Wait a few seconds before you press
the steam jet button 4
NOTE: For smoothing items of clothing that
are hanging up, you can use the steam jet
Button in a vertical position.
24 GB
and start ironing.
and pull out the
.
again.

8. Cleaning

DANGER!
Pull the mains plug 9 out of the wall
socket before you clean the steam iron.
Allow the device to cool down before
cleaning.
CAUTION:
Do not use any astringent or abrasive
cleaning agents.
Cleaning the device
• For cleaning the device, use a soft,
moistened cloth.
• Dirt can be removed from the sole
plate 20 using commercially available
cleaning agents for chrome, silver or
stainless steel.
• Residues that have melted on can be re-
moved by heating the steam iron up to
the MAX setting and then ironing an
old cotton cloth.
Self-cleaning
CAUTION:
Do not put vinegar, limescale remover
or any other additives into the water
tank 15. Additives can damage the de-
vice.
If you use tap water, you should run the self-
cleaning cycle after every use. Otherwise
use the self-cleaning cycle at least twice per
month.
1. Fill the water tank 15.
2. Place the steam iron in the stand 7.
3. Connect the mains plug 9 with the wall
socket.
4. Set the steam flow rate controller 3 to
and set the temperature control-
ler 17 to MAX.