Set Iron Temperature; Spray Function; Ironing Without Steam; Ironing With Steam - Silvercrest SDBK 2400 F5 Operating Instructions Manual

7.2 Set iron temperature

NOTE: The steam iron must be connected to
the stand 7 in order to heat up.
1. Figure C: Set the desired temperature
using the temperature controller 17:
- MIN the device is not getting hot
÷
- temperature: up to
approx. 110 °C
(synthetic materials)
÷÷
- temperature: up to
approx. 150 °C
(Silk, wool)
÷÷÷
- temperature: up to
approx. 210 °C
(linen, cotton)
- MAX maximum temperature
2. The temperature control lamp 14 is lit
for as long as the steam iron is heating.
It goes out when the set temperature has
been reached. You can then begin iron-
ing.

7.3 Spray function

Use the spray function in order to dampen
dry items of laundry. This option is available
irrespective of the set temperature. For this
purpose, the water tank 15 must be at least
one quarter full.
• Repeatedly press the spray button 5
While doing so, hold the steam iron
horizontally with the tip over the item of
laundry. Ensure that no water sprays
onto the ground.

7.4 Ironing without steam

Sensitive fabrics are ironed at lower temper-
atures and without steam. In order to damp-
en them, the spray function is available.
1. Set the steam flow rate control 3 to
and set the temperature controller 17 to
MIN.
2. Fill the water tank 15 if you wish to use
the spray function.
3. Place the steam iron in the stand 7.
4. Connect the mains plug 9 with the wall
socket.
5. Set the desired temperature using the
temperature controller 17. The tempera-
ture control lamp 14 lights up.
6. Start ironing as soon as the ironing tem-
perature has been reached and the tem-
perature control lamp 14 goes out.
7. Finish ironing, set the temperature con-
troller 17 to MIN and pull out the
mains plug 9.
8. Allow the steam iron to cool down, and
pour off any remaining water from the
water tank 15 through the filling open-
ing in the water tank (under the lid 2).

7.5 Ironing with steam

Steam ironing requires a high temperature,
at least the temperature setting for
der to additionally dampen items of cloth-
.
ing, the spray function is also available.
1. Set the steam flow rate control 3 to
and set the temperature controller 17 to
MIN.
2. Fill the water tank 15.
3. Place the steam iron in the stand 7.
4. Connect the mains plug 9 with the wall
socket.
5. Set the temperature controller 17 to the
desired temperature (at least
temperature control lamp 14 lights up.
6. As soon as the ironing temperature has
been reached and the temperature con-
trol lamp 14 goes out, adjust the steam
. In or-
). The
23
GB