Huawei NetCol8000-A Quick Manual page 36

9.3 Configuring Initial Parameters
1. Set the control mode based on the actual configuration of T/H sensors.
2. If a differential pressure switch is configured, set Indoor fan control type to Pressure diff ctrl.
(Optional) Teamwork Settings
9.4
The table uses 8 smart cooling products in CAN teamwork as an example.
Item
Air
Teamwo
No.
conditio
rk group
ner
no.
address
1 1 1
2 1 2
3 1 3
... ... ...
7 1 7
8 1 8
1. Teamwork group no.: A maximum of four groups, with the same teamwork control number,
can be assigned (1–4) for one teamwork networking.
2. Smart cooling product address: In a teamwork control group, each smart cooling product
address (1-32) must be unique, and the smart cooling product with minimum address is the
master smart cooling product.
3. Networking mode: The networking mode set on the screen must be consistent with the actual
networking mode.
4. Enable teamwork CAN resistor: Set the parameter if CAN teamwork is used. Set the parameter
to ON for the first and eight smart cooling products.
5. Number of smart cooling products in this group: Indicates the number of precision smart
cooling products in a group. The value is an integer ranging from 1 to 32.
6. Number of running smart cooling products in this group: Specifies the number of running
NetCol8000-As in a group. The value ranges from 1 to the number of NetCol8000-As in the
group.
7. Rotation function: Enable the active and standby smart cooling products to work alternately.
This function is recommended when the heat load is even.
Enable Teamw
teamwo ork Networkin
rk CAN functio g mode
resistor n
Yes Enable
No Enable
No Enable
... ...
No Enable
Yes Enable
Number of
air
conditioners
in this group
CAN
8
network
CAN
/
network
CAN
/
network
CAN
...
network
CAN
/
network
CAN
/
network
35
Number of
running air Rotation
conditioners function
in this group
6 (2 standby) Enable
/ /
/ /
... ...
/ /
/ /