Connecting Line Voltage - Mitsubishi Electric M-SERIES Installation Manual

13.2. Connecting line voltage

Make sure power supply is off.
14.2. Connecting line voltage
The unit should be installed by a licensed contractor/
Make sure power supply is off.
electrician. If required by applicable national, state and
The unit should be installed by a licensed contractor/electrician. If required by applicable national,
local codes; a disconnect switch will need to be installed
state, and local codes, a disconnect switch will need to be installed when the indoor unit is powered
when the indoor unit is powered from the outdoor unit. from the outdoor unit.
Remark:
* Use a ring tongue terminal in
order to connect a ground wire
to terminal.
Grounding Terminal*
NOTE: If the air handler will be installed with electric heat
package do not power the electric heat from the outdoor unit.
NOTE
If the air handler will be installed with electric heat package do not power the electric heat
All wiring must conform to National and Local codes
from the outdoor unit.
All wiring must conform to national and local codes
1. Remove the desired knockout on the air handler.
Function Table
2. Attach a conduit pipe connector to the air handler and route the wiring as shown in the above diagram.
Ensure conduit connection hole is air tight and add a sealant if necessary.
3. Firmly tighten all of the terminal screws. After tightening, verify that the wires are tightly fastened.
Mode
Power failure auto
restart
© 2020 Mitsubishi Electric US, Inc.
Indoor temperature
detecting
SVZ-KP12,18, 24, 30, 36NA
Grounding Terminal*
Not available
Available
Indoor unit operating average
42
Set by indoor unit's remote controller
Remote controller's internal sensor
Grounding
terminal*
Disconnect
switch
Settings
Specifications are subject to change without notice.
1. Remove the d
2. Attach a cond
wiring as shown
hole is air tight a
3. Firmly tighten
that the wires ar
Electrical Char
Model
Hz
A12
A18
A24 60
A30
A36