Replacing The Backlight - Mitsubishi Electric E1000 Series Service And Maintenance Manual

Hardware
3.7.9

Replacing the Backlight

Note:
All lamps in the display must be replaced at the same time.
To following is needed:
– A new backlight, see the
– A torx T10 screwdriver
– A screwdriver Phillips size 0 or 00 (only for E1151).
Note:
Make sure you have adequate ESD protection.
E1012, E1022, E1032, E1041, E1043, E1060, E1061, E1062, E1063,
E1070 and E1071
If the backlight is broken on a panel listed above, the entire display must be replaced.
To replace the display you will need a new display including plastic frame and display
cable, see the Available Spare Parts
play See Replacing the Display/Display Cable
E1100
To replace the backlight of E1100, follow the steps 1-5 in section
Cover for E1100. Then follow the steps below:
1. Gently move the backlight diagonally in direction from the display center to
release the snap-in closure that keeps the backlight in place.
2. Remove the backlight from the display.
3. Insert the new backlight. Be careful not to pull the cables of the new backlight
when inserting it, since pulling the cables will damage the backlight.
4. Re-assemble the complete operator panel.
42
Available Spare Parts list.
section. For information about changing the dis-
section.
backlight
backlight snap lock
Replacing the Rear
connectors
Mitsubishi Electric, MA00758A