Handset Cord; Line Cord; Recommendations For Installation - Siemens Profiset 3020 User Manual

Table of Contents

Advertisement

Available languages

Available languages

To install or replace the batteries, follow the
steps below:
• disconnect
the
telephone line.
• open the battery compartment (position
30).
• install four new batteries. Make sure that
the batteries have the correct polarity (i.e.
the polarity shown on the inside of the
compartment).
When the batteries are low, the low battery
indicator will appear on the display (position
27 on page 5).
You can install the external power supply
by connecting it to the telephone (position
18 on page 5) and to the AC power outlet.
30
Note:
• The telephone is designed so that you
can make calls even without batteries or
or the external power supply. However, in
these cases, call identification will not
work and the display may be switched
off.
• If you intend to an external power supply,
we recommend that you use the Siemens
power supply (C39280-Z4-C508).
telephone
from
34
31
32
33

Handset cord

Connect the long end of the handset cord
to the socket marked with the
the
(position 31). Insert the cord into the cable
duct (position 32) and attach the short end
to the handset.

Line cord

Connect the line cord to the socket marked
with the
cord into the cable duct (position 34).
Attach the other end to the telephone jack
(RJ11).

Recommendations for installation

Please observe the following guidelines:
• For your own safety and protection, do
not use the telephone in locations with
extreme heat or humidity. The telephone
is designed to operate at temperatures
between +5ºC and +55ºC and is not
water-proof.
• Some parts of the telephone, such as the
rubber
feet,
varnished furniture.
• Place the telephone at least one meter
away from devices such as cordless
phones or TV sets. These devices may
cause interference with the telephone.
• Use a damp or antistatic cloth to clean
the telephone. Never use a dry cloth
(danger of electrostatic discharge) or
abrasive cleaning agents.
• When the telephone reaches the end of
its service life, dispose of it in an
environmentally
accordance
requirements.
• Please dispose of used batteries in in an
environmentally friendly fashion.
6
symbol (position 33). Insert the
may
leave
friendly
with
the
symbol
marks
on
fashion,
in
local
legal

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hipath 1100

Table of Contents