Panasonic ER-GB80 Service Manual page 7

5. Driving block
Set the motor, module and battery assembly to the hous-
ing A.
Place the motor holder first and then inset the battery ter-
minal side.
NOTE:
Make sure that two motor lead wires are pressed fit
within the space between the battery holder and the
motor holder to prevent pinching.
6. Waterproof rubber
The waterproof rubber must be fitted the right way
around.
7. Housing O-ring
Apply the grease (FLOIL G714S) on the housing O ring.
Align the projection of the housing O-ring and the groove
of housing.
8. Trimmer
Set the trimmer on the housing.
9. Retaining plate
Attach two O-rings.
Hitch the projections of retaining plate first and press
down on the other side.
NOTE:
Make sure that the waterproof rubber is set properly.
10. Trimmer driving bar
Set the trimmer driving bar to the pin of driving head.
7
ER-GB80/ER-GB70/ER-GB60