Bosch NDN-498V03-21P Installation And Operation Manual page 76

76 en | Advanced Mode
Camera buttons
Disable the Camera buttons on the camera to prevent
unauthorized change of the camera settings.
Camera LED
Disable the Camera LED on the camera to switch it off.
Show test pattern
Select On to show a video test signal.
Pattern
Select the desired test pattern to help with installation and
fault-finding.
Restore all defaults
Click Restore all defaults to restore the factory defaults for the
camera. A confirmation screen appears. Allow 5 seconds for the
camera to optimize the picture after a mode reset.
Note:
The default IP address is restored. Connect to the camera again
using this address.
AR18-10-B006 | v1.1 | 2010.06 Installation and Operation Manual
FlexiDome2X IP Camera
Bosch Security Systems