Canon PRISMAsync v3.2 Technical & Service Manual page 36

System service mode (PRISMAsync service mode)
This button is used to temporarily switch to Normal mode. In this mode printing and scanning
is possible. You can re-enter SDS without the need of the PIN.
NOTE
Printing must be stopped before re-entering Service mode
2. Leave Service Mode
[3] Leave Service Mode
• Leave Service Mode: leaves the service mode and switch to the Normal User Mode. This is
used to temporarily leave Service Mode.
• End of service visit: leaves the service mode and the error analysis tab is cleared and an
entry in the data dump file is created before returning to the Normal User Mode.
3. Engine Service
The [Engine service] button is used enter the print engine service mode. All service
functionality is available.
NOTE
The <Updater> button is not supported in this screen and therefor the result is unpredictable.
The function of the other buttons is described in the service manual of the engine.
4. Firmware Upgrade
With this button you can start the upgrade procedure of the firmware of the copier.
A USB-stick containing the firmware should be available.
The upgrade is done from this USB-stick and not via the SST-tool. See the Service Manual of
the copier for detailed instructions.
5. Engine Reports
In the service mode a sorted list of all durables and periodically replaceable parts of the
engine and accessories can be generated and displayed on the LUI. The list is sorted by
36 Chapter 4 - Using the PRISMAsync
PRISMAsync V3.2