Solid-State Drive; Removing The M.2 2230 Solid-State Drive - Dell OptiPlex 7090 Service Manual

Steps
1. Align the hard-drive with the mounting points on the caddy and place the hard-drive onto it.
2. Pull the tabs on the right side of the caddy until the hard-drive clicks into place.
Next steps
1. Install the 2.5/3.5-inch hard-drive
2. Install the front bezel.
3. Install the side cover.
4. Follow the procedure in

Solid-state drive

Removing the M.2 2230 solid-state drive

Prerequisites
1. Follow the procedure in
2. Remove the side cover.
3. Remove the front bezel.
4. Remove the 2.5/3.5-inch
About this task
The following images indicate the location of the M.2 2230 solid-state drive and provide a visual representation of the removal
procedure.
caddy.
after working inside your
before working inside your
caddy.
computer.
computer.
Removing and installing components 23