Electrolux EA11S Manual page 5

Installing the water bottle
Before putting the water bottle:
1. Clean the inside of the water cooler,
where the water bottle is placed,
with warm water and mild detergent
and sterilize as indicated in Care
and cleaning section.
2. Clean and sterilize also the water
bottle, especially the part that will
be inside the water cooler.
3. Leave the protective plastic cap on
the bottle, where The product has a
hole punch.
If the user prefers not to use the hole
punch, you can pull it off. follow the
next instructions:
1. Remove the top cover with the hole
punch.
2. Turn clockwise the hole punch to fit
it in tears.
3. Remove the hole punch.
4. Replace the lid on the water
dispenser.
5. Place the water bottle at the water
cooler and make sure that it is well
docked.
7
This product was developed to be
used with bottles of 10 or 20 litres.
Depending on the maker and model of
the water bottle, there may be some
variation in size. Check, during
installation of the bottle, that it is well
supported and stable, and there is no
risk of falling.
Attention
Never turn the appliance upside down
or tilt it more than 45°.
Electrical installation
A short power-supply cord is provided
to reduce the risks resulting from
becoming entangled in or tripping
over a longer cord.
Connect the plug firmly, if the product
is connected to an adaptor plug or
extension cord, be sure it is not in an
area where it will be exposed to water.
After placing the water dispenser,
check if it is not over the power cord.
Important
We do not recommend the use of an
extension cord or adapter plug.
Do not fasten, twist or tie the power
cord.
Do not try to fix it. If it is damaged,
request the visit of a professional
technician. If the power cord is
damaged, it should be replaced by
the service centre technician.
Max. 45°
8