Signal Source "Dtv" (Digital Tv Reception); Automatic Digital Channel Search; Setup Menu For Signal Source "Dtv - Silvercrest LT 1510 User Manual And Service Information

Table of Contents

Available languages

Signal Source "DTV" (Digital TV Reception)

The built-in receiver allows you to watch terrestrial digital TV shows via an outdoor or indoor antenna

as well as digital TV shows from the cable TV network. Furthermore, the "DTV" (Digital TV) mode

also allows you to receive digital radio broadcasting stations. To do this, connect the correspond-

ing antenna cable to the RF input (see page 10, item 14) on the right panel of your LT 1510. When

using the device for the first time you must program the channels or perform an automatic channel

search.

With automatic digital channel search, your LT 1510 will store all available digital channels. In order

for the digital channel search to work properly, the signal source "DTV" must be selected (see page

19 - Selecting the Signal Source). Proceed as follows:

1. Press the INPUT button (30) on the remote control. The signal source selection menu will ap-

pear. Press the direction buttons (32) to select the signal source "DTV".

2. Press the MENU button (50) on the remote control to display the TV settings menu.

3. Press the direction button  (32) on the remote control three times to navigate to the "DTV"

option and press  to open it.

4. Press the direction button  (32) on the remote control to navigate to the "Auto Tuning" option

and press  to open it.

5. Select "Yes" and press OK on the remote control to launch the automatic channel search.

A window will display the current frequency band. A progress bar will inform you of the status of the

automatic channel search. All found stations will be automatically stored in a sequential list of chan-

nel presets.

After the search of the entire frequency band is completed, you're done. Then the first-found chan-

nel will be tuned-in. To cancel the process at any time, press MENU (50) on the remote control.

If you had already performed an automatic channel search in the past, all existing pre-

set channels will be replaced by the new ones found.

The setup menu lets you perform specific settings to customise the LT 1510 according to technical and

personal requirements. Press the MENU button (50) to open the setup menu. The menu is divided into

four items allowing you to adjust or change picture, sound, system preferences and channel settings.

Table of Contents

Table of Contents