Signal Source "Tv; Setup Menu For Signal Source „Tv; Navigating The Setup Menu - Silvercrest LT 2310 User Manual And Service Information

Signal Source "TV"

Signal Source "TV"
The built-in receiver allows you to watch terrestrial analogue TV shows via an outdoor or indoor an-
tenna as well as analogue TV shows from the cable TV network. To do this, connect the correspond-
ing antenna cable to the RF input (see page 8, item 13) on the back panel of your LT 2310. When
using the device for the first time you must program the channels or perform an automatic channel
search (see page 19 – Automatic Channel Search).
Setup Menu for Signal Source „TV"
The setup menu lets you perform specific settings to customise the LT 2310 according to technical and
personal requirements. Press the MENU button (53) to open the setup menu. The menu is divided into
six items allowing you to adjust or change picture, sound, system, function, channel and picture-in-
picture settings.

Navigating the Setup Menu

To open or exit the setup menu, press the MENU button (53) on the remote control. Press  or 
(35) on the remote control to select an item, then press  or  (35) on the remote control to select
an option. Adjust the desired value with the  or  buttons (35) on the remote control. To save the
settings and return, press the MENU button (53) on the remote control again or press EXIT (36).
You can also perform menu settings via the buttons located on the side panel of your LT 2310. To open
or exit the menu, press the MENU button (22) on the side panel and press the buttons VOL+ (23)
(right), VOL- (23) (left), CH+ (24) (up) or CH- (24) (down) to navigate the menu.
When you exit the menu by pressing the MENU button (22), all settings will be saved automati-
cally.
20