Canon imageCLASS MF3110 Software Manual page 147

You installed the applications on the MF3110 Setup CD-ROM but they were not registered in
the MF Toolbox.
Q Have you installed the applications with the MF Toolbox open?
A If you install the applications with the MF Toolbox open, the applications will not
be registered in the MF Toolbox. Click [Defaults] to register them. (See
"Scanning with the MF Toolbox," on p. 3-6.)
When you click a button on the MF Toolbox, another application opens.
Q Is the application selected correctly for that button?
A Click a button on the MF Toolbox and select the application you want to open for
that button. Repeat for the other buttons. (See "MF Toolbox Settings," on p. 3-9.)
Changed settings in a dialog box are not activated (Windows Me/2000).
Q Did you restart your computer after changing the settings?
A In Windows Me/2000, if you open [Scanners and Cameras] in the [Control
Panel] folder and change the settings in the [Events] tab, the settings will not be
activated unless you restart your computer. Once you have changed your
settings, restart your computer.
Scanned images look dirty.
Q Is the platen glass or the platen glass cover clean?
A Clean the platen glass or the platen glass cover.
Q Is the image size too small?
A Some applications do not display an image properly at small sizes. Try
displaying the image at 100% magnification.
Q Does the monitor display color set at below 16 bits?
A In [Display Properties], set the display colors to 16-bit color, 24-bit color or
higher.
White lines appear on one edge of the image you scan.
Q Is the document placed on the platen glass correctly?
A Place the document approximately
glass.
1
/ " (3 mm) from the left edge of the platen
8
Scanning Problems
4
4-9