Display And Menu; Select An Input Source - NEC FA Series Quick Start Manual

4.2 Display and Menu
For the LED Wall, the video controller is normally set to sending card mode. This
means the video controller receives the video signal from a PC, processes the video
signal and sends it to the LED Wall. The display of the video controller in normal
operation (home screen) is shown below.
A
H
Figure 4: Display of Video Controller in Sending Card Mode
A Device Name
B
• With Input Source: LED Wall
resolution and color depth
• No Input Source: Display control
status
C IP Address or Sending Card Name
D Front Panel Locked/Unlocked*
* To lock or unlock all the buttons, press the Function knob and Back
button simultaneously for 3 seconds.
4.2.1 Select an Input Source
The following input sources are supported:
• 3G-SDI
• Single-Link DVI
• HDMI
Select an input source that matches the type of the external video source.
Notice
The following constraints apply for the input sources:
• Only one video input source can be selected at the same time.
• Interlaced SDI video sources do not support low latency.
• SDI video sources do not support the following functions: Color depth adjustment, preset
resolution, custom resolution, image mirroring.
1. On the home screen, press the Function knob to enter the menu.
Select Input Settings and press the Function knob to see the settings.
2.
Select Input Source and press the Function knob to enter the submenu.
3.
4. Select the target video source and press the Function knob to enable it.
B
G F
E
Screen brightness
F
Operating Status (Backup, Alarms,
Connected Ports)
G
Connection Status of Ethernet Ports
H Video Source
12
C
E
D