Table of Contents
Advertisement
■Locking-type cover plate shaft TSMD0041 for use
When using wire hanging device must be used when locking a coil axis cover TSMD0041.
Wire
retaining
pin hole
Shaft cover plate
knurled screw （back-out）
Shaft
cover
plate
Install wire tray：
a)
The wire plate retaining pin holes at the damping plate shaft retaining pin，set the wire
spool；
b)
Plate shaft knurled screw the lid out of state in rotation, clockwise rotating disk shaft
cover, install it to disk axis damping；
c)
Appropriate adjustments to disk drive shaft cover and wire the relative position of the
knurled screw aligned wire plate retaining pin holes and knurled screw to limit the cover
of freedom of rotation, to prevent them from damping plate axis, thus ensuring reliable
wire rotating disk.
Remove the wire tray: a note on the steps by reverse operation can be.
Wire Spool
plate
②
③
Shaft cover plate
knurled screw (screwing in）
Damping
shaft
retaining pin
①
5
Damping
plate
shaft
plate
Advertisement
Table of Contents
