Table of Contents
Advertisement
Gas check
Lock Button
Record/Call
Pulse Button
Current display
panel switch
Voltage display
panel switch
Press "Switch", the arc closing indicator light is on, and the digital tube
displays the arc closing parameters. Press the button again, the initial
indicator light is on, and the digital tube displays the initial parameters.
●It is used for gas inspection (gas flow adjustment and gas presence
confirmation).
The air valve opens after being pressed, and the air valve will not close
after being released, and the corresponding indicator light is on. Press
the air valve again to close, and the corresponding indicator light goes
out.
●The panel is adjustable when it is turned on for the first time, and the
lock indicator is off. Long press this button for more than 3 seconds,
the indicator will light up, and the panel lock is not adjustable.
●The first time it is turned on, the default is no storage/recall status.
Press this button and the indicator light will be on continuously, which
means that the parameters of a certain channel are recalled. The
digital tube displays the parameters and welding mode at this time.
Press this button again, the indicator light flashes, indicating that the
current welding parameters and status are stored in a channel.
●The first time it is turned on, there is no pulse state by default and the
indicator light is off. Press the button, the indicator light will light up,
indicating that the current is pulse welding.
Spot welding: Weld according to the set spot welding time, and
automatically stop welding when the spot welding time is up.
●Current display and adjustment, current indicator light is on.
●Wire feeding speed display and adjustment, the wire feeding speed
indicator light is on.
●Board thickness display and adjustment, the board thickness
indicator lights up.
To switch the above three parameters, you need to use the switch
button. Press the switch button repeatedly, and the three parameters
will be displayed in a loop.
●Voltage display and adjustment, the voltage indicator light is on.
●Arc length display and adjustment, the arc length indicator light is on.
●The arc characteristic display and adjustment, the arc characteristic
indicator light is on.
To switch the above three parameters, you need to use the switch
button. Press the switch button repeatedly, and the three parameters
will be displayed in a loop.
7
Advertisement
Table of Contents
