Table of Contents
Advertisement
6 Preparation for use
(1) Feed roller installation
There are two grooves on the feed
roller. Please confirm the size of the
groove
before
indication stamp of wire diameter
must be seen outside.
(2) Wire setting
Turn the Knob screw to
rightward and remove it from
the spool shaft.
Set the wire spool.
Return the Knob screw and fix it
tightly.
Raise the pressure arm and insert
wire 2～3cm into the SUS tube.
Replace the pressure arm and
tighten with the pressure nut.
Press the inching button on the
wire feeder.
Release from the inching button
when the wire comes out 1～
2cm from the tip of torch.
installation,
The
Spool hole
⑨
⑧
Rotor pin
Spool shaft
①Pressure nut
④SUS Tube
①
④
③
Lock nut
Wire size indication
4
Wire Spool
Knob screw
⑥
⑦
②Pressure arm
③Feeder roller
⑤Wire guide
②
①
Pressure nut
③
①Pressure nut
Wire
Advertisement
Table of Contents
