Sealey SA72 Instructions

ITEM PART NO. DESCRIPTION
1 SA72/01 DRIVE GEAR SHAFT
2 SA72/02 NEEDLE ROLLER
3 SA72/03 BEVEL GEAR
4 SA72/04 BEARING
5 SA72/05 SAW BLADE FLANGE HOLDER
6 SA72/06 SAW BLADE BOLT FLANGE
7 SA72/07 BOLT,HEX SOCKET CAP HEAD
8 SA72/08 BEVEL GEAR CASING (GREY)
9 SA72/09 BEARING
10 SA72/10 EXTERNAL STOP RING
11 SA72/11 CASING COVER
12 SA72/12 GUIDE PLATE
13 SA72/13 SPRING WASHER
14 SA72/14 BOLT
15 SA72/15 MAIN SHAFT
16 SA72/16 NEEDLE ROLLER
17 SA72/17 BEARING
18 SA72/18 SPACER COLLAR
19 SA72/19 IDLER GEAR
20 SA72/20 INTERNAL GEAR
21 SA72/21 BEARING SUPPORT
22 SA72/22 DRIVE SHAFT
23 SA72/23 BEARING
24 SA72/24 INTERNAL GEAR
25 SA72/25 INTERNAL STOP RING
Issue Date: 230701
Issue No:
Date Modified:
ITEM PART NO. DESCRIPTION
26 SA72/26 DISTANCE NUT
27 SA72/27 THROTTLE HANDLE
28 SA72/28 AIR INLET BUSHING
29 SA72/29 THROTTLE VALVE
30 SA72/30 VALVE
31 SA72/31 O-RING
32 SA72/32 THROTTLE SPRING
33 SA72/33 THROTTLE VALVE PLUG
34 SA72/34 O-RING
35 SA72/35 THROTTLE LEVER
36 SA72/36 SPRING PIN
37 SA72/37 ROTOR
38 SA72/38 REAR END PLATE
39 SA72/39 SPRING PIN
40 SA72/40 BEARING
41 SA72/41 ROTOR BLADE
42 SA72/42 CYLINDER
43 SA72/43 FRONT END PLATE
44 SA72/44 BEARING CAP
45 SA72/45 WASHER
46 SA72/B BLADE, 50x1x12.7mm 150 TPU. HSS
47 SA72/47 WRENCH, L-SHAPED
48 SA72/48 WRENCH, HEX, L-SHAPED
49 SA72/49 BEARING
Thank you for purchasing a Sealey Product. Manufactured to a high standard this product will, if used according to these instructions
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL
REQUIREMENTS, WARNINGS AND CAUTIONS. USE THIS PRODUCT CORRECTLY AND WITH CARE FOR THE
PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/ OR PERSONAL
INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY INSTRUCTIONS
 WARNING! Ensure Health & Safety, local authority, and general workshop practice regulations are adhered
to when using this equipment.
 WARNING! Disconnect from air supply before changing the blade, servicing or performing maintenance.
Maintain the saw in good condition (use an authorised service agent).

Replace or repair damaged parts. Use genuine parts only. Non-authorised parts may be dangerous and

will invalidate the warranty.
Use in suitable clean and tidy working area, free from unrelated materials and ensure there is adequate

lighting.
 WARNING! Always wear approved eye, face and hand protection when operating the saw
Remove ill fitting clothing. Remove ties, loose jewellery, and contain and/or tie back long hair.

Wear appropriate protective clothing and keep hands and body clear of working parts.

Maintain correct balance and footing. Ensure the floor is not slippery and wear non-slip shoes.

Keep children and unauthorised persons away from the working area.

1 Check moving parts alignment on a regular basis.

N/A
Ensure workpiece is secure before operating the saw. Never hold a workpiece by hand. Use a vice or clamps.

 WARNING! Ensure correct air pressure is maintained and not exceeded. Recommended pressure 50-90psi.
Keep air hose away from heat, oil and sharp edges. Check air hose for wear before each use and ensure

that all connections are secure.
Prolonged exposure to vibration from this saw poses a health risk. It is the Employers/Owners and

operator's responsibility to correctly assess the potential hazard and issue guidelines for safe periods of use
and offer suitable protective equipment.
DO NOT use any power source except an air compressor.

DO NOT operate the saw near any inflammable substance or on any container that once contained an

inflammable substance.
DO NOT use the saw for a task it is not designed to perform.

DO NOT operate saw if

any parts are damaged or
missing as this may cause
failure and/or personal
injury.
DO NOT carry the saw by

the hose, or yank the hose
from the air supply.
DO NOT operate saw

when you are tired, under
the influence of alcohol,
drugs or intoxicating
medication.
DO NOT carry the saw with your finger on the trigger.

DO NOT direct air from the air hose at yourself or others.

When not in use disconnect from air supply and store in a safe, dry, childproof location.

INSTRUCTIONS FOR:
AIR SHEET SAW
SA72
MODEL No:
SA72 Issue No.2 21/09/09