Toro Cab Kit Operator's Manual page 13

4. Route the wire harness behind the cab and
under the seat, and secure the clip on the wire
harness to the side panel
Figure 19
1. Wire harness
5. Install the black ground wire to the ground wire
on the Power Converter Kit wire harness
20).
Note:
The black terminal ring is not used.
6. Install the red power wire to the power wire on
the Power Converter Kit wire harness
20).
Figure 20
1. Cab wire harness
2. Black ground wire with
terminal ring (not used)
(Figure 19).
g035260
(Figure
(Figure
g278776
3. Black ground wire with
spade terminal
4. Red power wire with spade
terminal
7. Connect the remaining wire to the fused wire on
the new fuse block
8. Lower the bed and connect the battery; refer to
the Operator's Manual.
9. Install the previously removed seat base.
13
(Figure 17).