Advertisement
The Dell EMC Edge 510 LTE is a purpose-built, high-value appliance for Edge use case that supports SD-WAN with an
integrated LTE adapter.
For detailed installation information, including instructions for the wall mount and optional dual rackmount tray installation, see
the Dell EMC Edge 510 LTE Installation Guide at www.dell.com/support.
After unpacking the Edge 510 LTE, inspect the device and immediately report any damage to your Dell EMC sales
representative.
Topics:
•
Installation instructions
•
Activation issues
•
Specifications
Installation instructions
Information icon definitions:
● The Warning icon signals information about hardware handling that could result in injury.
● The Caution icon signals information about situations that could result in equipment damage or lost of data.
● The Note icon signals important operational information.
Install the device
WARNING:
To avoid electrostatic discharge (ESD) damage, wear grounding wrist straps when handling this
equipment.
Install the device in an area that meets the following safety requirements:
● Near a properly grounded AC power outlet.
● In a temperature-controlled room with a continuous temperature range from 0°C to 40°C (32°F to 104°F)
● In a dry, clean, and well-ventilated room away from heat sources such as hot air vents or direct sunlight
● Away from severe electromagnetic noise
● Away from direct view within the workplace
The numbers one through four in the following figure correspond to the setup procedure:
4
Edge 510 LTE
Edge 510 LTE
1
Advertisement
