priority priority
Defaults
Command Modes
INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.6.1.0
7.5.1.0
6.5.1.0
spanning-tree mstp edge-port
Configures the interface as an MST edge port and optionally a Bridge Protocol Data Unit (BPDU) guard.
C9000 Series
Syntax
spanning-tree mstp edge-port [bpduguard [shutdown-on-violation]]
Parameters
mstp edge-port
bpduguard
•
•
Enter keyword priority then a value in increments of 16 as the
priority. The range is from 0 to 240. The default is 128.
•
cost = depends on the interface type
•
priority = 128
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Enter the keyword mstp then the keywords edge-port to
configure the interface as a Multiple Spanning Tree edge port.
(OPTIONAL) Enter the keyword portfast to enable Portfast to
move the interface into forwarding mode immediately after the
Port Channel interface with one 10 Gigabit Ethernet =
2000
Port Channel with two 10 Gigabit Ethernet = 1800
Multiple Spanning Tree Protocol (MSTP)
1437