Debug Ip Pim - Dell C9000 Series Reference Manual

If you use this command on a peer VLT node, only the synced routes are deleted from
the multicast route table.

debug ip pim

View IP PIM debugging messages.
C9000 Series
Syntax
debug ip pim [bsr | events | group | packet [in | out] | register
| state | timer [assert | hello | joinprune | register]]
To disable PIM debugging, use the no debug ip pim command or use the undebug
allto disable all debugging command.
Parameters
bsr
events
group
packet [in | out]
register
state
timer [assert |
hello | joinprune |
register]
Defaults Disabled.
Command Modes EXEC Privilege
(OPTIONAL) Enter the keyword bsr to view PIM Candidate
RP/BSR activities.
(OPTIONAL) Enter the keyword group to view PIM messages for
a specific group.
(OPTIONAL) Enter the keyword group to view PIM messages for
a specific group.
(OPTIONAL) Enter the keyword packet to view PIM packets.
Enter one of the optional parameters:
• in: to view incoming packets
• out: to view outgoing packets
(OPTIONAL) Enter the keyword register to view PIM register
address in dotted decimal format (A.B.C.D).
(OPTIONAL) Enter the keyword state to view PIM state
changes.
(OPTIONAL) Enter the keyword timer to view PIM timers. Enter
one of the optional parameters:
• assert: to view the assertion timer
• hello: to view the PIM neighbor keepalive timer
• joinprune: to view the expiry timer (join/prune timer)
• register: to view the register suppression timer
PIM-Sparse Mode (PIM-SM) 1672