The multicast commands are supported by Dell Networking operating system.
This chapter contains the following sections:
•
IPv4 Multicast Commands
NOTE:
Dell Networking OS supports Multicast routing only on default VRFs .
IPv4 Multicast Commands
The following section contains the IPv4 multicast commands.
clear ip mroute
Clear learned multicast routes on the multicast forwarding table. To clear the protocol-independent multicast
(PIM) tree information base, use the clear ip pim tib command.
C9000 Series
Syntax
clear ip mroute {group-address [source-address] | * | snooping}
Parameters
group-address
[source-address]
*
snooping
Command Modes
EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Enter the multicast group address and source address (if
desired), in dotted decimal format, to clear information on a
specific group.
Enter * to clear all multicast routes.
Enter the keyword snooping to delete multicast snooping route
table entries.
32
Multicast
Multicast
1393