Managed-Config-Flag - Dell C9000 Series Reference Manual

Use the ipv6 neighbor command to manually configure the IPv6 address of a neighbor
to be discovered by the switch.

managed-config-flag

Set the managed address configuration flag.
C9000 Series
Syntax
managed-config-flag {on | off}
To clear the flag, use the no managed-config-flag {on | off} command.
Parameters
on
off
Defaults none
Command Modes
CONFIGURATION
CONFIGURATION TERMINAL BATCH
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.10(0.0)
9.9(0.0)
9.7(0.0)
9.7(0.0)
NOTE: The parameters vrf, mac-address, interface are not supported in the batch
mode.
Enter the keyword on to set the managed-config-flag value as
ON.
Enter the keyword off to set the managed-config flag value as
OFF.
Description
Introduced the Configuration Terminal Batch mode on C9010.
Introduced on the C9010.
Introduced on the S6000-ON.
Introduced on the S4810, S4820T, S5000, S6000, and Z9000
switches.
Neighbor Discovery Protocol (NDP) 1446