Ip Domain-Name - Dell C9000 Series Reference Manual

Version
7.5.1.0
Usage Information To fully enable DNS, also specify one or more domain name servers with the ip name-
server command.
The system does not support sending DNS queries over a VLAN. DNS queries are sent
out on all other interfaces, including the Management port.
To view current bindings, use the show hosts command.
Related
Commands

ip domain-name

Configure one domain name for the switch.
C9000 Series
Syntax
ip domain-name name
To remove the domain name, use the no ip domain-name command.
Parameters
name
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
Description
Introduced on the C-Series.
• ip name-server — specifies a DNS server
• show hosts — Views the current bindings.
Enter one domain name to complete unqualified names (that is,
incomplete domain names that cannot be resolved).
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
IPv4 Routing 1191