Hg-Link-Bundle-Monitor Enable - Dell C9000 Series Reference Manual

pkts
Rate info (interval 15 seconds):
rate
line-rate
Related show hardware hg-stats
Commands bundle.

hg-link-bundle-monitor enable

Enable the monitoring of link utilization and traffic distribution in backplane HiGig link bundles/port channels
on a line-card or switch fabric module (SFM) NPU.
C9000 Series
Syntax
hg-link-bundle-monitor {sfm npu-id hg-port—channel hg-port—
channel-id | slot slot npuUnit npu-id hg-port—channel 0} enable
To disable HiGig link-bundle monitoring, use the no version of this command.
Parameters
sfm npu-id hg-
port-channel hg-
port-channel-id
slot slot-id
npuUnit npu-id
hg-port-channel
0
enable
Command Mode CONFIGURATION
Command History
Version
9.9(0.0)
9.2(1.0)
9.3.0.0
0 packets, 0 bytes 0 underruns
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte
0 Multicasts, 0 Broadcasts 0 Unicasts
0 throttles, 0 discarded, 0 collisions 0 wredDrops
0 Green WredDrops 0 Yellow WredDrops, 0 Red WredDrops
Input 00.00 Mbits/sec,
Output 00.00 Mbits/sec,
— displays traffic statistics from internal ports in a HiGig link
Specify a HiGig port channel on a switch SFM (spine) NPU by
entering the keyword sfm and SFM NPU ID, then hg-port-
channel and a HiGig port channel ID. SFM NPU IDs are 0 to 1;
SFM HiGig port-channel IDs are 0 to 10.
Specify a HiGig port channel on a line-card (leaf) NPU by
entering the keyword slot and slot number, then npuUnit and
line-card NPU ID, then hg-port-channel 0. Line-card slot
numbers are 0 to 11; line-card NPU ID is 0 . The HiGig port-
channel ID range is from 0 to 2.
Enable HiGig link-bundle monitoring.
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the Z9000 switch.
0 packets/sec, 0.00% of line-
0 packets/sec, 0.00% of
Interfaces 1033