Usage Information By default, iSCSI is enabled on the unit and the flow control is enabled on all of the
interfaces. It is also acts as defaults when the link-level flow control is enabled on one
or more interfaces.
To enable DCB, do one of the following:
Enables priority flow control or enhance transmission selection on interface.
Related
dcb <ets | pfc> enable
Commands
selection on interface.
PFC Commands
The following PFC commands are supported on the Dell Networking OS.
clear hardware pfc-nodrop-priority
Clear the drop statistics.
Syntax
clear hardware pfc-nodrop-priority l2-dlf drops stack-unit stack-
unit-number port-set port-pipe
Parameters
stack-unit stack-
unit-number
port-set port-pipe
Command Modes
EXEC
EXEC Privilege
Command History
Version
9.10(0.0)
Related
pfc-nodrop-priority l2-dlf drop
Commands
flooding on lossless priorities.
•
Apply the dcb-input policy command with the no pfc-mode command on
to all the interfaces.
•
Disable flow-control on all of the interfaces.
— enable priority flow control or enhanced transmission
Enter the keywords stack-unit and the stack unit number.
The range is from 0 to 5.
Enter the keywords port-set and port-pipe number. The port-
pipe number is 0.
Description
Introduced on the C9010, S6000, S6000–ON, Z9100–ON and
S6100–ON.
— configures to drop the unknown unicast packets
Data Center Bridging (DCB)
681