Neighbor Timers - Dell C9000 Series Reference Manual

Parameters
subnet-number
mask
Defaults Not configured.
Command Modes ROUTER BGP
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
8.3.11.1
7.8.1.0
7.7.1.0

neighbor timers

Set keepalive and hold time timers for a BGP neighbor or a peer group.
C9000 Series
Syntax
neighbor {ip-address | peer-group-name} timers keepalive holdtime
To return to the default values, use the no neighbor {ip-address | peer-
group-name} timers command.
Parameters
ip-address
peer-group-name
keepalive
Enter a subnet number in dotted decimal format (A.B.C.D.) as
the allowable range of addresses included in the Peer group.
To allow all addresses, enter 0.0.0.0/0.
Enter a prefix mask in / prefix-length format (/x).
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the Z9000.
Introduced on the S-Series.
Introduced on the C-Series.
Enter the IP address of the peer router in dotted decimal format.
Enter the name of the peer group to set the timers for all routers
within the peer group.
Enter a number for the time interval, in seconds, between
keepalive messages sent to the neighbor routers. The range is
from 1 to 65535. The default is 60 seconds.
Border Gateway Protocol 490