Version
9.9(0.0)
9.2(1.0)
7.4.1.0
Usage Information Enables periodic audits of the software and hardware copies of the IPv4 forwarding
table. Use this command in Configuration Terminal Batch mode to enable the audits in
the chassis connected in a dual-homing setup.
clear alarms
Clear alarms on the system.
C9000 Series
Syntax
clear alarms
Command Modes
EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.12.0
8.3.11.1
8.1.1.0
7.6.1.0
7.5.1.0
E-Series
Usage Information This command clears alarms that are no longer active. If an alarm situation is still active,
it is seen in the system output.
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the E-Series.
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the Z9000.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Original command.
Control and Monitoring
78