Match Interface - Dell C9000 Series Reference Manual

Parameters
community-list-
name
exact
Defaults Not configured.
Command Modes ROUTE-MAP
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
8.3.11.1
8.3.7.0
8.1.1.0
7.6.1.0
7.5.1.0
6.1.1.0
Related
ip community-list
Commands
set community
neighbor send-community

match interface

To match routes whose next hop is on the interface specified, configure a filter.
C9000 Series
Syntax
match interface interface
To remove a match, use the no match interface interface command.
Parameters
interface
Enter the name of a configured community list.
(OPTIONAL) Enter the keywords exact to process only those
routes with this community list name.
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— configures an Community Access list.
— specifies a COMMUNITY attribute.
— sends COMMUNITY attribute to peer or peer group.
Enter the following keywords and slot/port or number
information:
Access Control Lists (ACL) 364