Redundancy Primary - Dell C9000 Series Reference Manual

Networking command-line reference guide

Hide thumbs Also See for C9000 Series:

Table of Contents

redundancy primary

Set an RPM as the primary RPM.

C9000 Series

redundancy primary [rpm0 | rpm1]

To delete a configuration, use the no redundancy primary command.

The RPM in slot R0 is the Primary RPM.

Command Modes

CONFIGURATION

Command History

This guide is platform-specific. For command information about other platforms, see

the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

— Pre-provision the specified port-extender stack unit.

Enter the keyword rpm0 to set the RPM in slot R0 as the primary

Enter the keyword rpm1 to set the RPM in slot R1 as the primary

Introduced on the C9010.

Introduced on the S4820T.

Introduced on the S4810.

Introduced on the E-Series ExaScale.

Introduced on the C-Series.

Introduced on the E-Series.

High Availability (HA)

Table of Contents