V-VLT tagged
Name: TenGigabitEthernet 10/0
802.1QTagged: False
Vlan membership:
Q
U
Name: TenGigabitEthernet 10/1
802.1QTagged: False
Vlan membership:
Q
U
Related
Commands
show interfaces transceiver
Display the physical status and operational status of an installed transceiver. The output also displays the
transceiver's serial number.
C9000 Series
Syntax
show interfaces [tengigabitethernet slot/port | fortyGigE slot/
port | peGigE pe-id/stack-unit/port ] transceiver
Parameters
tengigabitethernet For a 10G interface, enter the keyword tengigabitethernet
fortyGigE
peGigE
G - GVRP tagged, M - Trunk
i - Internal untagged, I-Internal tagged, v-VLT untagged,
Vlans
1
Vlans
1
•
interface
— configures a physical interface on the switch.
•
show ip interface
— displays Layer 3 information about the interfaces.
•
show interfaces
— displays information on a specific physical interface or virtual
interface.
•
show interfaces transceiver
of an installed transceiver. The output also displays the transceiver's serial number.
then the slot/port (ports or port range) information.
For a 40G interface, enter the keyword fortyGigE then the
slot/port (ports or port-range)information.
For a port extender Gigabit Ethernet interface, enter the
keyword peGigE then the pe-id / stack-unit / port-id
information. The pe-id range is from 0 to 255; the stack-unit
unit-number range is from 0 to 7; and the port-id range is from
1 to 48.
— displays the physical status and operational status
NOTE:
The peGigE option is only visible when the
feature extended bridge feature is enabled.
Interfaces
995