Show Interfaces - Dell C9000 Series Reference Manual

show interfaces

Display information on a specific physical or virtual interface, or the interfaces of the same type on a line card.
C9000 Series
Syntax
show interfaces [interface] [linecard slot-id]
From a PE console, use show interfaces to view the information on a specific
physical or virtual interface.
Parameters
interface
linecard slot-id
Command Modes
Enter one of the following keywords and slot/port or number
information:
•
•
•
•
•
•
•
•
•
Enter the linecard slot-id parameters to specify the switch
ports on a line card. The range of slot IDs is from 0 to 11.
• EXEC
• EXEC Privilege
For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
For a Null interface, enter the keywords null 0.
For a Port Channel interface, enter the keywords port-
channel then a number. The range is 1 to 128.
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
For a tunnel interface, enter the keyword tunnel then the
tunnel ID. The range is from 1 to 16383.
For a port extender Gigabit Ethernet interface, enter the
keyword peGigE then the pe-id / stack-unit / port-id
information. The pe-id range is from 0 to 255; the stack-
unit unit-number range is from 0 to 7; and the port-id
range is from 1 to 48.
NOTE: The peGigE option is only visible when the
feature extended bridge feature is enabled.
Interfaces 957