Ip Igmp Snooping Fast-Leave - Dell C9000 Series Reference Manual

Version
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
7.6.1.0
7.5.1.0
Usage Information To enable IGMP snooping, enter this command. When you enable this command from
CONFIGURATION mode, IGMP snooping enables on all VLAN interfaces (except the
default VLAN). Use this command in Configuration Terminal Batch mode to enable
IGMP snooping in a dual-homing setup.

ip igmp snooping fast-leave

Enable IGMP snooping fast-leave for this VLAN.
C9000 Series
Syntax
ip igmp snooping fast-leave
To disable IGMP snooping fast leave, use the no igmp snooping fast-leave
command.
Defaults Not configured.
Command Modes
INTERFACE
INTERFACE (BATCH Mode)
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.10(0.0)
9.9(0.0)
9.5(0.1)
Description
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
NOTE: Execute the no shutdown command on the VLAN interface for IGMP
Snooping to function.
Description
Introduced the Configuration Terminal Batch mode on C9010.
Introduced on the C9010.
Introduced on the Z9500.
Internet Group Management Protocol (IGMP) 1146