Hg-Link-Bundle-Monitor Rate-Interval; Hg-Link-Bundle-Monitor Trigger-Threshold - Dell C9000 Series Reference Manual

Usage Information You can configure HiGig link bundle monitoring so that a system log message or an
SNMP trap is generated when traffic distribution in a bundle is uneven. The formula that
determines uneven traffic distribution is predefined.

hg-link-bundle-monitor rate-interval

Specify the interval (in seconds) for polling traffic distribution in the member links of a HiGig link bundle.
C9000 Series
Syntax
hg-link-bundle-monitor rate-interval seconds
To restore the default value, use the no version of this command.
Parameters
seconds
Command Mode CONFIGURATION
Command History
Version
9.9(0.0)
9.2(1.0)
9.3.0.0
Defaults The default polling interval for HiGig link bundles is 15 seconds.
Usage Information The rate interval used to poll member links is globally configured and applied to all
HiGig link bundles in the system.

hg-link-bundle-monitor trigger-threshold

Specify the bandwidth-percentage threshold used in HiGig link-bundle monitoring to determine uneven
traffic distribution and when an alarm is generated.
C9000 Series
Syntax
hg-link-bundle-monitor trigger-threshold percentage
To restore the default value, use the no version of this command.
Parameters
percentage
Command Modes CONFIGURATION
Polling interval in seconds. The valid values are from 10 to 299.
Description
Introduced on the C9010.
Introduced on the Z9500 switch.
Introduced on the Z9000 switch.
Trigger threshold (in percentage of link-bundle bandwidth) at
which an SNMP trap is generated. Valid values are 1 to 90.
Interfaces 1034