Version
9.7(0.0)
ipv6 neighbor
Configure a static entry in the IPv6 neighbor discovery.
C9000 Series
Syntax
ipv6 neighbor{ipv6-address} {interface interface}
{hardware_address}[vrf vrf-name]
To remove a static IPv6 entry from the IPv6 neighbor discovery, use the no ipv6
neighboripv6–address{interface interface
Parameters
ipv6-address
interface
intehardware_rfac
e
Description
Introduced on the S4810, S4820T, S5000, S6000, and Z9000
switches.
Enter the IPv6 address of the neighbor in the x:x:x:x::x format.
NOTE:
The :: notation specifies successive hexadecimal
fields of zero.
Enter the keyword interface then the interface type and slot/
port or number information:
•
For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
•
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port/subport
information.
•
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
•
For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
•
For a port channel interface, enter the keywords port-
channel then a number.
•
For a Null interface, enter the keyword null then the Null
interface number.
•
For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
•
For a tunnel interface, enter the keyword tunnel then the
tunnel interface number. The range is from 1 to 16383.
•
For a port extender Gigabit Ethernet interface, enter the
keyword peGigE then the pe-id / stack-unit / port-id
information. The pe-id range is from 0 to 255; the stack-
Neighbor Discovery Protocol (NDP)
1444