Ip Pim Join-Filter - Dell C9000 Series Reference Manual

The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
8.2.1.0
7.6.1.0
Usage Information When an NSF-capable router comes up, it announces the graceful restart capability and
restart duration as a Hello option. The receiving router notes the Hello option.
Routers not NSF-capable discard the unknown Hello option and adjacency is not
affected.
When an NSF-capable router goes down, the neighboring PIM speaker preserves the
states and continues the forwarding of multicast traffic while the neighbor router
restarts.

ip pim join-filter

Permit or deny PIM Join/Prune messages on an interface using an extended IP access list. This command
prevents the PIM-SM router from creating state based on multicast source and/or group.
C9000 Series
Syntax
ip pim join-filter ext-access-list
To remove the access list, use the no ip pim join-filter ext-access-list
command.
Parameters
ext-access-list
Defaults none
Command Modes
INTERFACE
INTERFACE (BATCH Mode)
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.10(0.0)
Description
Introduced on the C9010.
Introduced on the E-Series ExaScale. Added the ipv6 option for
the E-Series.
Introduced on the E-Series.
Enter the name of an extended access list.
Description
Introduced the Configuration Terminal Batch mode on C9010.
PIM-Sparse Mode (PIM-SM) 1677