Ip Pim Rp-Address - Dell C9000 Series Reference Manual

Version
7.8.1.0
7.6.1.0
Usage Information The access name is an extended IP access list that denies PIM register packets to RP at
the source DR based on the multicast and group addresses. Do not enter this
command before creating the access-list
.

ip pim rp-address

Configure a static PIM rendezvous point (RP) address for a group or access-list.
C9000 Series
Syntax
ip pim rp-address address {group-address group-address mask}
[override]
To remove an RP address, use the no ip pim rp-address address {group-
address group-address mask} [vrf vrf-name] [override] command.
Parameters
address
group-address
group-address
mask
override
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.8(0.0)
Description
Introduced on the C-Series and S-Series.
Introduced
Enter the RP address in dotted decimal format (A.B.C.D).
Enter the keywords group-address then a group-address
mask, in dotted decimal format (/xx), to assign that group
address to the RP.
Enter the keyword override to override the BSR updates with
static RP. The override takes effect immediately during enable/
disable.
NOTE: This option is applicable to multicast group range.
Description
Introduced on the C9010.
Introduced on the S3048-ON and S4048-ON.
PIM-Sparse Mode (PIM-SM) 1682