Show Ip Pim Tib - Dell C9000 Series Reference Manual

Version
8.3.12.0
8.3.11.1
8.1.1.0
7.8.1.0
Usage Information The following describes the show ip pim neighbor command shown in the
following example.
Field
Neighbor address
Interface
Uptime/expires
Ver
DR prio/Mode
Example
Dell#show ip pim neighbor↵
Neighbor Interface Uptime/Expires Ver DR↵
Address Prio/Mode↵
127.87.3.4 Te 1/16 09:44:58/00:01:24 v2 1 / S↵

show ip pim tib

View the PIM tree information base (TIB).
C9000 Series
Syntax
show ip pim tib [group-address [source-address]]
Parameters
group-address
Description
Introduced on the S4810.
Introduced on the Z9000.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Description
Displays the IP address of the PIM neighbor.
List the interface type, with either slot/port information or ID
(VLAN or Port Channel), on which the PIM neighbor was found.
Displays the amount of time the neighbor has been up then the
amount of time until the neighbor is removed from the multicast
routing table (that is, until the neighbor hold time expires).
Displays the PIM version number.
• v2 = PIM version 2
Displays the Designated Router priority and the mode.
• 1 = default Designated Router priority (use the ip pim
dr-priority command)
• DR = Designated Router
• S = Sparse mode
(OPTIONAL) Enter the group address in dotted decimal format
(A.B.C.D).
PIM-Source Specific Mode (PIM-SSM) 1664