Show Ip Interface - Dell C9000 Series Reference Manual

Version
8.3.11.1
8.3.10.0
8.5.1.0
8.1.1.0
7.9.1.0
7.6.1.0
7.5.1.0
6.1.1.0
Usage Information This command provides egress port information for a given IP flow. This information is
useful in identifying which interface the packet follows in the case of Port-channel and
Equal Cost Multi Paths. Use this command for routed packed only. For switched
packets, use the show port-channel-flow command.
The show ip flow command does not compute the egress port information when
load-balance mac hashing is also configured due to insufficient information (the
egress MAC is not available).
S-Series produces the following error message: %Error: Unable to read IP
route table.
Example
Dell#show ip flow interface Te 1/8 189.1.1.1 63.0.0.1 protocol
tcp source-port 7898 destination-port 8
flow: 189.1.1.1 63.0.0.1 protocol 6 7868 8976
Ingress interface:Te 1/20
Egress interface:Te 1/14 to 1.7.1.2[CAM hit 103710] unfragmented
packet
packet

show ip interface

View IP-related information on all interfaces.
C9000 Series
Syntax
show ip interface [interface | brief] [linecard slot-id]
[configured]
Description
Introduced on the Z9000.
Introduced on the S4810.
Added support for 4-port 40G line cards on ExaScale.
Introduced on the E-Series ExaScale.
Introduced VRF on the E-Series.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Te 1/10 to 1.2.1.2[CAM hit 103710] fragmented
IPv4 Routing 1219