Garp Timers - Dell C9000 Series Reference Manual

Version
8.3.19.0
8.3.11.1
8.3.7.0
7.6.1.0
Related
gvrp enable
Commands
protocol gvrp

garp timers

Set the intervals (in milliseconds) for sending GARP messages.
C9000 Series
Syntax
garp timers {join | leave | leave-all}
To return to the previous setting, use the no garp timers {join | leave |
leave-all} command.
Parameters
join
leave
leave-all
Defaults As above.
Description
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on C-Series, E-Series, and S-Series
— enables GVRP on physical interfaces and LAGs.
— access GVRP protocol.
Enter the keyword join then the number of milliseconds to
configure the join time. The range is from 100 to 147483647
milliseconds. The default is 200 milliseconds.
NOTE: Designate the milliseconds in multiples of 100.
Enter the keyword leave then the number of milliseconds to
configure the leave time. The range is from 100 to 2147483647
milliseconds. The default is 600 milliseconds.
NOTE: Designate the milliseconds in multiples of 100.
Enter the keywords leave-all then the number of
milliseconds to configure the leave-all time. The range is from
100 to 2147483647 milliseconds. The default is 1000
milliseconds.
NOTE: Designate the milliseconds in multiples of 100.
GARP VLAN Registration (GVRP) 899