Dampening - Dell C9000 Series Reference Manual

dampening

Configure dampening on an interface.
C9000 Series
Syntax
dampening [[[[half-life] [reuse-threshold]] [suppress-threshold]]
[max-suppress-time]]
Parameters
half-life
reuse-threshold
suppress-
threshold
max-suppress-
time
Defaults Disabled.
Command Modes INTERFACE (conf-if-)
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.12.0
8.3.11.1
8.1.1.0
7.6.1.0
7.5.1.0
Enter the number of seconds after which the penalty is
decreased. The penalty decreases half after the half-life period
expires. The range is from 1 to 30 seconds. The default is 5
seconds.
Enter a number as the reuse threshold, the penalty value below
which the interface state is changed to "up". The range is from 1
to 20000. The default is 750.
Enter a number as the suppress threshold, the penalty value
above which the interface state is changed to "error disabled".
The range is from 1 to 20000. The default is 2500.
Enter the maximum number for which a route can be
suppressed. The default is four times the half-life value. The
range is from 1 to 86400. The default is 20 seconds.
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the Z9000.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Interfaces 924