Link-Bundle-Distribution Trigger-Threshold - Dell C9000 Series Reference Manual

If disabled, the CLI would inform the FIB to re-program the destination prefix paths with
no weights or regular ECMP.
Example
Dell(conf)#ip ecmp ?
weighted
Dell(conf)#ip ecmp weighted
Dell(conf)#do show running-config | grep ecmp
ip ecmp weighted
Dell(conf)#
Dell(conf)#no ip ecmp ?
weighted
Dell(conf)#no ip ecmp weighted
Dell(conf)#do show running-config | grep ecmp
link-bundle-distribution trigger-
threshold
Provides a mechanism to set the threshold to trigger when traffic distribution begins being monitored on an
ECMP link bundle.
C9000 Series
Syntax
link-bundle-distribution trigger-threshold [percent]
To exit from ecmp group mode, use the exit command.
Parameters
percent
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
9.0.0.0
8.3.19.0
Enables Weighted ECMP
Disables Weighted ECMP
Indicate the threshold value when traffic distribution starts being
monitored on an ECMP link bundle. The range is from 1 to 90%.
The default is 60%.
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the Z9000.
Introduced on the S4820T.
Equal Cost Multi-Path (ECMP) 847