Dell C9000 Series Reference Manual page 620

Parameters
ipv6-address
prefix-length
mask
route-map map-
name
Defaults Not configured.
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Command History
Version
9.9(0.0)
9.2(1.0)
8.2.1.0
7.4.1.0
Usage Information The software resolves the network address configured by the network command with
the routes in the main routing table to ensure that the networks are reachable via non-
BGP routes and non-default routes.
Related redistribute
Commands
Enter the IPv6 address in the x:x:x:x::x format followed by the
prefix length in the /x format. The range is /0 to /128.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
Enter the mask of the IP address in the slash prefix length format
(for example, /24). The mask appears in command outputs in
dotted decimal format (A.B.C.D).
(OPTIONAL) Enter the keywords route-map followed by the
name of an established route map. Only the following ROUTE-
MAP mode commands are supported:
• match ipv6 address
• match ipv6 next-hop
• match ipv6 route-source
• set ipv6 next-hop
If the route map is not configured, the default is deny (to drop
all routes).
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the E-Series ExaScale.
Introduced
– redistributes routes into BGP.
Border Gateway Protocol 620