Dell C9000 Series Reference Manual page 663

Parameters
all
queue-number
Defaults Clear per-queue rate-limiting counters for all control-plane and port traffic.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.8.0
Usage Information To display the per-queue counters of rate-limited control-plane traffic at the
aggregated (switch), use the show control-traffic queue command.
Example
Dell#clear control-traffic queue 2 counters
Dell#
Enter the keyword all to clear counters for rate-limited traffic
on all CPU queues, including Route Processor, Control
Processor, and line-card CPUs.
Enter the queue number to clear counters for rate-limited traffic
on a specified CPU queue. The range of queue-number values is
from 0 to 20. The twenty-one control–plane queues are divided
into groups of seven queues for the Route Processor, Control
Processor, and line-card CPUs as follows:
• Queues 0 to 6 process packets destined to the Control
Processor CPU .
• Queues 7 to 13 process packets destined to the Route
Processor CPU.
• Queues 14 to 20 process packets destined to the line card
CPU.
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Control Plane Policing (CoPP) 663